High Quality And Reliable Baler Manufacturer
The metal baler can squeeze various metal scraps, steel shavings, scrap steel, scrap iron, scrap copper, scrap aluminum, aluminum shavings, disassembled car shells, waste oil drums and other metal raw materials into various shapes such as rectangular solids and cylinders. Qualified charge. It is convenient for storage, transportation and recycling.
Features
The metal baler series equipment has the following characteristics:
1. All adopt hydraulic drive, work smoothly, safe and reliable.
2. Use manual or PLC automatic control mode of operation.
3. There are four ways of discharging: side-turning bag, side-pushing bag, forward-pushing bag or no-out bag.
4. No foot screws are required for installation, and diesel engines can be used as power in places where there is no power supply.
5. Product specifications and types: The metal baler has 63 to 600 tons, 10 varieties and more than 20 specifications, which can meet the different needs of customers at different levels.
Working principle:
Place the packing materials in the packing box of the packing machine, and the hydraulic oil cylinder will work to suppress the packing materials, and the packing materials will be compressed and formed into various metal bales.
Product advantages:
The machine is adopted, easy to move and install, simple to operate, easy to maintain, reliable in sealing, and does not require foot screws during installation.
Users can customize the packing specifications and sizes according to their needs to maximize the cooperation with transportation or storage. It is a good equipment to improve labor efficiency, reduce labor intensity, save manpower, and reduce transportation costs.
Trouble phenomenon:
The metal baler is normally turned on, and the tape is automatically sent after the package is finished, and the tape is unlimited. Solution: Check whether the machine is working normally except for automatic tape feeding. If there are no malfunctions in other parts, it is likely that there is a problem with the potentiometer.
Potentiometer, on the front of the packer, there are a total of four buttons on the operation panel, from left to right are the power switch, potentiometer, reset button, and belt feed button. The potentiometer of the baler is a rotary button with a scale around it, which is used to control the length of the automatic tape after the packing is completed. If there is more than one tape sending and the automatic sending tape is no problem, it is mostly caused by a potentiometer malfunction.
Troubleshooting:
The debugging method, turn the potentiometer to a small scale, and then fine-tune, the machine can feed the tape normally within a range. If the tape feeding is normal in a certain interval, it can be affirmed that the potentiometer is faulty. The next step is to replace the potentiometer.
It is recommended to use a control potentiometer.
Operation method:
1. Use a small screwdriver to remove the small screw fixed on the black knob, and remove the black knob.
2. Unscrew the fixing screw and pull out the potentiometer from the inside. It can be seen that the potentiometer has three outlet positions, two of which are connected to the computer board, and the other is open.
3. Remember the wire sequence and remove the potentiometer with a soldering iron. Then replace with a new potentiometer.
4. Reinstall the potentiometer again.
